User Guide

1
4
5
6
7
8
9
10
2
3
11
INPUT,
OUTPUT,
AND ALL
THOSE
FUNKY
BUTTONS
.
1. Program and bank selector footswitches These
footswitches provide access to the User banks/programs.
2. Power adaptor input This is where the DOD PS200R
power supply is connected. Use only the DOD PS200R, other
adaptors may damage the VoTEC, and void the warranty.
3. Controller Connect optional DOD VCC1 to have real time
control over mix levels. Also controls wah ranges, and auto-
wah/envelope sensitivity.
4. Effect selector buttons These buttons allow you to select the
effects you wish to use or bypass.
5. Display The LED display in program mode shows which bank
and program is currently selected. In Edit mode it shows the
number and/or status of the selected effect.
6. Store Button Use this button to store your custom programs in
the user memory location of choice.
7. XLR Output Connect VoTEC to mixer here.
8. XLR input Connect your microphone here.
9. Up/Down buttons These buttons scroll up/down selected
effects (edit mode), or up/down through banks/presets
(performance mode).
10. Input Knob Controls the overall input level from your mic.
11. Clip LED The clip LED lights when clipping occurs at the input
of the VoTEC, To eliminate clipping, reduce the setting of
your input level by adjusting the Input knob. Allow the LED to
light occasionally with peak signals.
12. 1/4” HiZ Output jack Connect cable from this jack to your
mixers input, also doubles as headphone output.
13. 1/4” HiZ Input jack Plug in your microphone here.
VoTEC OWNERÕS MANUAL
MULTI EFFECTS PROCESSING
12
13