Owner`s manual

FOR UNBALANCED AMPLIFIER CONNECTION:

To make an

unbalanced

connection to the unit's XLR connectors, wire the line

connectors as follows:

Pin 2: high

Pin 3: NO CONNECTION

Pin 1: ground

Use tip-sleeve 1/4" phone plug connectors for connection to the amplifiers,

wired as follows:

tip: high

sleeve: ground

Note: The 834 1/4" jacks may be connected balanced or unbalanced and that

the 835 has both balanced and unbalanced outputs. Input impedance is 40K

ohms, and output impedance is 102 ohms.

Once the crossover is installed, adjusted, and tested, an optional security

panel may be secured to the front panel of the unit to prevent tampering.

ETUP

Consult your speaker and driver manufacturer's specifications for the recom-

mended crossover frequencies. Basic setup procedures for the crossovers

are as follows:

• Label each power amplifier for its respective frequency band.

834: LOW, MID, or HIGH for stereo operation; LOW, LOW-MID, HIGH-

MID, or HIGH for mono operation.

835: LOW, HIGH for stereo operation or LOW, MID, HIGH for mono

operation.

• Set each power amplifier volume control at maximum and connect each

power amplifier output to its correct speaker or driver. DO NOT TURN ON

THE POWER AMPLIFIERS YET.

• Apply power to the crossover.

STEREO OPERATION

Using the markings in the top row of the front and rear panels, set each chan-

nel as follows:

• Set the gain control to 0 dB. Set all level controls to -∞ and switch in the

40 Hz high-pass filter if desired (834 only).

Signal Processors 18-0121-B 6/8/99 10:24 AM Page 13