Instruction manual

Introduction

Opening/closing the external connector terminal cap

■ Opening

Hook your finger on the slot and open the

cap in the direction of arrow.

Slot

■ Closing

Close the cap by pressing securely in the

direction of arrow.

Attaching/removing the back cover

■ Removing

Hold the FOMA terminal and hook your finger on

the slot to remove the back cover in the direction

of arrow without applying exc

essive force on it.

Slot

■ Attaching

Inser t the back cover into the FOMA

terminal in direction

① and push the back

cover down securely in direction

②.

Securely push the areas illustrated by and

make sure that there is no space between the

back cover and the FOMA terminal.

・

When removing the back cover, make sure that you drain water (p.20) and wipe moisture off the FOMA terminal.

・

When attaching the back cover, make sure that no dust or dirt adheres to the back cover (especially to the rubber packing).

・

Water or dust might enter the inside of the FOMA terminal unless you attach the back cover securely.

・

When attaching the back cover, make sure that the UIM, the microSD card and the battery pack are attached

securely. If the UIM or microSD card is not securely inserted, the battery pack sits on the UIM or microSD card which

causes a gap between the FOMA terminal and the back cover when attaching the back cover. The waterproof/

dustproof function might deteriorate because of the gap.