Instruction manual


 
The display is
dim
• Has the screen backlight
timeout been set? → P205
• Has the screen brightness
been adjusted? → P205
• Is the battery level low?
→ P39
• Has power safe been set?
→ P211
• Hardware
key control
mode is
activated
• When any damage of
this terminal or display is
detected, "Hardware key
control mode" screen is
displayed. Move "Mode
On"/"Ask me later"/"Screen
OFF" up and down by
volume keys and use power
key to conrm. You can use
power key and volume key
to operation incoming calls
or alarm.
– To answer a call, press
both volume keys at the
same time.
 
• Hardware
key control
mode is
activated
– To stop alarm, press and
hold down volume key
(up)/volume key (down).
• You can set Hardware key
control mode beforehand.
– While power is turned
o󰮏, press power key,
volume key (up) and
volume key (down) for
over six seconds at
the same time. Move
"On"/"O󰮏"/"Cancel" up and
down and use power key
to conrm.
266
