Instruction manual

Sending les to client device via
SmartShare Beam



a
u

b

c
u
• You can also set up by
u
"SmartShare
Beam".
d

• When sending via Wi-Fi Direct, turn on
SmartShare Beam on the client device
of the receiving side beforehand and
register the device in "Add device".
• When sending via Bluetooth function,
pairing with a client device of the receiving
side beforehand and register the device in
"Add device".
• When the device is not displayed, tap
"Rescan" to scan the device.
• It is sent when Bluetooth is connected.
• When connecting Wi-Fi Direct, the device
is checked with check mark. When adding
a device of the sending side, place a
check mark in another device.
e

Receiving les to client device via
SmartShare Beam


a


• is displayed on the status bar. Data
reception starts.
• You can conrm the reception condition
from notication panel.
• When data is received, a message screen
is displayed at the bottom of the screen.
246
