User's Manual

9
Dockmate is a registered trademark from PPA-Electronics B.V.
Leuvensesteenweg 177 – BE-3191 Boortmeerbeek – Belgium
VAT BE 0891.773.260 – Tel. [phone] – Mob. [phone]
[e-mail] – www.dockmate.eu – [e-mail] – www.ppa-electronics.com
5. Charging the batteries
The Dockmate TWIST transmitter is fitted with a Li-Ion battery that has to be charged
occasionally.
When the Dockmate TWIST transmitter is turned on, both LEDs will go white. Then
the Status LED will show one of the following:
Battery fully charged More than 3.90V
Battery OK Between 3.45V and 3.90V
Battery Warning Between 3.45V and 3.30V
Battery Failed Less than 3.30V
Battery Failed Less than 3.00V
It is not possible to turn on the transmitter when the battery voltage drops below
3.30V.
It is highly recommended to charge the transmitter when the LED shows orange on
the starting up.
The Dockmate TWIST transmitter will start to charge when switched off and placed
on the Dockmate Cradle or wireless charger. The LEDs on the charger will change in
color from solid red to solid green indicating the charging process.
When the indicator on the charger flashes red that means a foreign metal object
was placed on the charging pad or the charger is overheated.
Also the Status LED on the transmitter will start to flash in different colors depending
on the battery percentage ( 0-50%: , 50-80% : , 80-100% ).
When the battery is fully charged the Dockmate transmitter will shut down
automatically and the charger will show a red led.
When the battery is fully charged, there will be no reaction when the
transmitter is placed on the charger. After some use, when the
voltage drops, it will be possible to charge the transmitter again.