Installation Guide

The Style Drawer Series outlets include a 100˚-
120˚F resettable thermostat to protect against
overheating inside the drawer. To reset, correct the
source of over temperature and push the button in
the center of the vents of the cover plate. Note: You
may need to wait a few minutes for the unit to cool
before the thermostat can be reset.
The GFCI outlet has a green LED which will light
if there is power to the outlet. If the LED is not
lit, check the GFCI reset button, the thermostat,
and that the line, neutral, and ground wires are
connected properly.
Note: For a successful Style Drawer Series
installation, it is NOT necessary to touch anything
inside the receptacle box. However, if the outlet
needs to be removed, reference the above diagram.
Green Wire (Ground): Green Screw
White Wire (Neutral): Silver Screw
Receptacle Box Wiring
Black Wire (Line): Brass Screw
STYLE DRAWER BLADE DUO PART #: 0290-20324 0290-20324-I 0290-20324-U 0290-20324-UI 0290-20321 0290-20321-I 0290-20321-U 0290-20321-UI
Have questions? Need help? Call us!
[e-mail]
www.dockingdrawer.com
[phone]
12893 Alcosta Blvd, Suite M,
San Ramon, CA 94583
TM
How to Operate the Outlet
Junction Box Wiring
Max output: 3 amps. Perfect for charging cell
phones, tablets, and laptops.
Docking Drawer
Blade™
Docking Drawer
Blade Duo™
CHARGING
Style Drawer
Flush™
Style Drawer
Blade™
Style Drawer
Blade Duo™
POWERING
Complete Outlet Lineup
TM
Max output: 20 amps, GFCI outlets. Perfect for
powering hair dryers, curling irons, and small
kitchen appliances.
Step 8 - Connect electrical supply to the Style
Drawer outlet according to the wiring diagram on
oppostire page. For more details about locating an
in-cabinet electrical supply for your Docking Drawer
installation, please refer to the Electrical Planning
Guide located in the Specication Library at www.
dockingdrawer.com.
Step 7 - Install the cover plate.
Step 6 - Align arms. With the drawer mostly
closed, mark the position of the rear mounting
bracket. It is important to make sure the drawer
moves freely in and out and that the arms are
square and even. Spend sucient time at this step
before fastening the bracket to the rear wall to
make sure everything is square and the arms are in
the correct position. Once that is done, secure with
the screws provided.
CUTOUT TEMPLATE for Style Drawer Blade Duo
FOR ACCURACY SCALE PRINTER TO 100%




KMG041519