Manual

Table Of Contents

PGS-5 Gripper Short Manual

Pgs-5 is controlled by IO, and the electromagnetic claw is directly connected with the

control box. Three wires are led out from the control box, respectively, which are 24V, GND

and h/l. Se 1 and se 2 currently have no outgoing lines, which can be used to expand the

connection sensor of control box or not connect. Three wires are connected for control,

respectively, 24V, GND and h/l. The specific connection is as follows:

Note

·When using the H / L pin to control the gripper, it is necessary to keep the dial switch in

the closed position

The controller (PLC / controller) can control the opening and closing of the

electromagnetic claw by outputting the voltage signal corresponding to h / L.