Manual

Table Of Contents

PGS-5 Gripper Short Manual

Description of Control box

Control box

The clamping claw is equipped with a control box, which is mainly used to control the

opening and closing of the electromagnetic claw. As shown in Figure 2.1:

Figure 2.1 Control box

Instructions

·Indicator

：When the signal is given to the electromagnetic gripper, the indicator light will

be on, but if the signal is not given, the indicator light will be off.

·Dial switch: Manually control the opening and closing switch of electromagnetic gripper.

·Gripper interface: Used to connect the cable of electromagnetic gripper.

Through the dialing control inside the control box, as shown in the red box in Figure 2.2

below. The IO input signal of gripper can be set to NPN or PNP.( Input 0V valid or 24V

valid)

Figure 2.2 Dial switch

Please refer to the following to configure NPN or PNP, as shown in Table 2.1:

Table 2.1 corresponding IO signal table

Dial 1 (up)

dial 2

(down)

0V valid

1(ON)

0(OFF)

24V valid

0(OFF)

1(ON)

Wiring instructions