Manual

Table Of Contents

DobotVisionStudio User Guide

129

• By Line: inputting source is the result of finding line.

• By Point: you can customize or link the start point, end point and angle of the line.

• By Coordinate: you can customize or link the X/Y coordinate of the line's start point, and

end point.

• Running Operation: see L2C Measure for details.

L2L Measure Results

• By Angle: the angle difference between two lines.

• Distance: the average distance from four end points of the line to another line.

• Absolute Distance: the absolute value of distance.

• Intersection Point X/Y: the intersection point X/Y coordinate of extension lines of two

lines.

P2C, P2L, P2P Measure

For P2C, P2L and P2P measurement, please refer to L2C Measure. You can set the output of

corresponding tools according to your demands.

Intensity Measure

The tool of intensity measurement is used to measure grayscale average value and standard deviation

of all pixels within the ROI of the measured image. Select the image source in the operating area

first, drag the intensity measurement algorithm module into the operating area, and connect the

module in turn using the operating line. You can use ROI tool to select area and narrow the search

range. Click Run to see the result, as shown below.

Output Results

• Min./Max. Value: Min./Max. grayscale value

• Average Value: grayscale average value