Manual

DobotVisionStudio User Guide
Issue V4.1.2 (2022-06-08) User Guide Copyright © Yuejiang Technology Co., Ltd.
117
Drag the Find Angle Bisector module to the process editing area. Complete the connection with
other modules and ensure that other relevant modules have been connected with the module before,
such as Line Search.
Steps:
1. Double-click Find Angle Bisector module to enter the parameter edit window as shown below.
2. Select the image data source in Input Source
3. Subscribe the input source of Line 1 and Line 2 respectively. There are three kinds of input sources
for lines: by line, by point and by coordinate.
• By Line: Directly subscribe a line from the results of the previous module.
• By Point: Need to subscribe two points from the results of the previous module as the start
point and end point of the line.
• By Coordinate: Need to subscribe four coordinates from the results of the previous module
as the X and Y coordinates of the start point and the end point respectively.
NOTE
 After selecting one mode to subscribe a data source, when you switch to the other two
modes, the module will automatically get the corresponding data source of the other
modes.
4. Switch to Result Display of the module and set the specific module, color and transparency of the
image.
5. Click Execute or Continue to view the operation results as shown below.