Manual
Table Of Contents
- 1. Introduction
- 2. FlickerLED Demo
- 3. AlarmLED Demo
- 4. AdjustLED Demo
- 5. Button Demo
- 6. SeedVoiceLED Demo
- 7. MoveBlock Demo
- 8. SeedVoiceDobot Demo
- 9. JoyStick Demo
- 10. DobotPixy Demo
- Appendix A Common Function Description
- Appendix B Installing Suction Cup Kit
- Appendix C Pixy Install and Configure Pixy
- Appendix D Vision Recognition Initialization Process
- Appendix E Multiplexed I/O Interface Description of V1 Dobot Magician
- Appendix F Multiplexed I/O Interface Description of V2 Dobot Magician
Arduino Kit Demo Description 2 FlickerLED Demo
Issue V2.1 (2019-12-05) Demo Description Copyright © Yuejiang Technology Co., Ltd
3
FlickerLED Demo
Introduction
This Demo uses the Arduino to turn on and off the LED indicator.
Hardware Connection
The LED indicator and Arduino Mega2560 controller board are required in this demo. Figure
2.1 shows its connection process.
Figure 2.1 FlickerLED Connection
NOTE
If you connect the skill kit to other interfaces on the Arduino Mega2560, you also need
to modify the right interfaces that the skill kit connects to in the SmartKit.h file.
Program 2.1 Define the interfaces that the skill kit connects to
#define JOYSTICK_XPIN 7 // Interface that the X-axis of the JoyStick connects to
#define JOYSTICK_YPIN 6 // Interface that the Y-axis of the JoyStick connects to
#define JOYSTICK_ZPIN A5 // Interface that the Z-axis of the JoyStick connects to
#define LED_REDPIN 9 // Interface that the red LED indicator connects to
#define LED_GREENPIN A1 // Interface that the green LED indicator connects to
#define LED_BLUEPIN A3 // Interface that the blue LED indicator connects to