Manual
Table Of Contents
- 1. Introduction
- 2. FlickerLED Demo
- 3. AlarmLED Demo
- 4. AdjustLED Demo
- 5. Button Demo
- 6. SeedVoiceLED Demo
- 7. MoveBlock Demo
- 8. SeedVoiceDobot Demo
- 9. JoyStick Demo
- 10. DobotPixy Demo
- Appendix A Common Function Description
- Appendix B Installing Suction Cup Kit
- Appendix C Pixy Install and Configure Pixy
- Appendix D Vision Recognition Initialization Process
- Appendix E Multiplexed I/O Interface Description of V1 Dobot Magician
- Appendix F Multiplexed I/O Interface Description of V2 Dobot Magician
Arduino Kit Demo Description 10 DobotPixy Demo
Issue V2.1 (2019-12-05) Demo Description Copyright © Yuejiang Technology Co., Ltd
62
Pixy Install and Configure Pixy
Before debugging the DobotPixy Demo, you need to install and configure the Pixy vision
sensor.
Prerequisites
The PixyMon has been installed, which is obtained from arduino kit/PixyMon.
The suction kit has been installed on the end of Dobot Magician.
The cubes have been obtained.
Procedure
Attached figure 6 loosen the screws