User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 1 Security Precautions
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
3
phenomenon. At that point, you need to click J3+ under Joint coordinate system on the
M1Studio page to jog robotic arm to the position where the J3 value is above 10mm, and
then the alarm will be cleared.
When powering on for the first time, please ensure that the emergency stop switch has
been opened (The emergency stop button is bumped). Otherwise, the robotic arm will not
work normally. If the emergency stop switch is not opened, please rotate the emergency
stop button clockwise. The emergency stop button will be bumped when rotating to 45°.
Please DO NOT connect power cable to Dobot M1 directly without power adapter.
Otherwise, the machine will be damaged.