User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
82
Prerequisites
You have connected Dobot M1 to a PC over a network cable.
You have powered on Dobot M1.
The IP address of Dobot M1 and the PC must be in the same network segment. For details,
please see 5.5.3 Setting IP Address.
You have obtained the latest firmware.
You have connected Dobot M1 to an emergency stop switch.
Procedure
The Web Management page is displayed.
The Update Firmware page is displayed, as shown in Figure 6.35.
Figure 6.35 Update Firmware GUI
You can view the process of the firmware upgrade. If the progress bar is 100%, the
update is completed, as shown in Figure 6.36.
Figure 6.36 Process of the firmware upgrade