User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
77
Figure 6.27 Click feedstock extruder
If the melted filament flows from the nozzle of the extruder, the extruder is working
properly.
Click -Z or Click 10, 1, 0.1 to move Dobot M1 to the position where the distance
from nozzle to the printing platform is about 0.3mm, as shown in Figure 6.28.
Figure 6.28 Move Z-axis
NOTE
During printing, if the distance from Dobot M1 to the printing platform is too large or
too small to paste the first layer, it can lead to the nozzle blockage. For increasing the
stickiness of the first layer, placing a masking paper on the platform is recommended.