User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
76
Click to connect Dobot M1.
The printing window is displayed and the current printing temperature is shown
on the top corner of the window, as shown in Figure 6.26.
Figure 6.26 Printing window
Set Temperature to 200 and press down Enter to heat the extruder.
The temperature of the extruder should be above 170℃. Dobot M1 will not start
3D printing until the filament is in the melting state. So you need to heat the
extruder first.
DANGER
The heating rod will produce high temperature up to 250℃, please be careful. Do not let
children play with it alone. The process needs to be monitored when it is running. After
the process is completed, please turn off the equipment promptly.
Before printing, you need to test the extruder to check whether the melted filament
flows from the nozzle of the extruder.
Click the feedstock extruder or click the given stepper, such as 10, 1, 0.1 (10 is
recommended) on the Operational page and feed up to 10mm-30mm, as shown in
Figure 6.27.