User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
74
Parameter
Description
Please set to 150mm
Machine center 0,0
Machine center, please select it
GCode Flavor
The style of GCode
Please select RepRap Marlin/Sprinter
Build area shape
Build the area shape
Please select Circular
Serial port
Serial port
Please select the corresponding serial port
Baudrate
Baud rate
Please set to 115200
NOTE
The maximum width of 3D printing that Dobot M1 supports is 200mm, the maximum
depth is 200mm, and the maximum height is 220mm. Please make 3D-print in the Dobot
M1 workspace.
Set slice parameters, and select File > Open Profile to import these parameters,
as shown in Figure 6.23.
Figure 6.23 Import slice parameters
The 3D printing effect depends on the slice parameters. This topic provides a
configuration sample, you can import it directly for printing.