User Guide

Table Of Contents

Dobot M1 User Guide 6 Operation

If Connect turns to Disconnect, the connection is successful.

Select Tools > Web Management on the M1Studio page.

The Web management page is displayed.

Select Update Firmware in the navigation tree on the left.

The Update Firmware page is displayed, as shown in Figure 6.19.

Figure 6.19 Update Firmware GUI

Select 3D Printing Firmware on the Update Firmware page, and click One-

click Update to update 3D printing firmware directly.

Select Home in the navigation three on the left.

The Home page is displayed.

Select 3D printing Mode from the drop-down list on the Mode Switch

Controlling pane of the Home page and click Switch, as shown in Figure 6.20.

Figure 6.20 Switch 3D printing