User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
71
can be burned.
Do not focus the laser on people or animals.
Do not let children play with it alone. The process needs to be monitored when it is
running. After the process is completed, please turn off the laser promptly.
After performing this step, you will not need to adjust the focus manually when you
engrave next time. You can click SyncPos directly after importing picture.
Operating 3D Printing
Prerequisites
Dobot M1 has been powered on.
You have connected Dobot M1 to a PC over network cable or router.
The IP address of Dobot M1 and the PC must be in the same network segment. For details,
please see 5.5.3 Setting IP Address.
You have connected Dobot M1 to a PC over a serial cable.
Dobot M1 has been connected to an emergency stop switch.
The 3D printing kit has been installed. For details, please see 3.3.2 Installing 3D
Printing Kit.
Slice software Cura has been installed. The download path is
https://ultimaker.com/en/products/cura-software/list.
Please download the recommended version V14.07. The way how to install and use is not
descripted in this topic.
The 3D printing model and the firmware have been prepared.
The printing platform has been prepared and please place it in the workspace.
NOTICE
If SN number of Dobot M1 is DT2018xxx, please switch 3D printing mode directly to
start 3D printing without update. You can view the SN number on the Help > About
M1Studio page.
xxx indicates the random number, please replace it based on site requirements.
Procedure