User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
68
No.
Description
3
The running log of Dobot M1
4
The corresponding codes of the blockly module on the
programming window
The Save Blockly File page is displayed.
Operating Laser Engraving
Prerequisites
Dobot M1 has been powered on.
Dobot M1 has been connected to a PC successfully.
The laser kit has been installed. For details, please see 3.3.1 Installing Laser Engraving
Kit.
The picture to be engraved and materials to be processed have been prepared.
The lasing protective eyeglass has been prepared.
Procedure
The Laser Engraving page is displayed, as shown in Figure 6.16.
Figure 6.16 Laser Engraving GUI