User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
66
The Script page is displayed
You can double-click the interface used, the corresponding interface will be
displayed on the script file page, as shown in Figure 6.14. You can also click
icon of the corresponding interface on the left pane of the Script page to view the
way how to set the parameters. The scripting example can refer to Installation
directory/M1Studio/config/ststore/Example.script.
NOTICE
If you use the motion command when scripting, please add the orientation command
before every motion command, which indicates the arm orientation of Dobot M1.
Figure 6.14 Write a script
The Save Scrip File page is displayed.
The running log will be displayed on the lower pane of the Script page for checking.
Operating Blockly
Prerequisites
Dobot M1 has been powered on.
Dobot M1 has been connected to a PC successfully.