User Guide

Table Of Contents

Dobot M1 User Guide 1 Security Precautions

Security Precautions

This topic describes the security precautions that should be noticed when using this product.

Please read this document carefully before using the robotic arm for the first time. This product need

to be carried out in an environment meeting design specifications, you cannot remold the product

without authorization, otherwise it could lead to product failure, and even personal injury, electric

shock, fire, etc. People who use this product for system design and manufacture must be trained by

our company, relevant institution, or must have the same professional skills. The installation

personnel, operators, teaching personnel, programmers and system developers of the robotic arm

must read this document carefully and use the robotic arm strictly according to the regulations of

this document strictly.

1.1 General Security

DANGER

Robotic arm is an electrical equipment. Non-professional technicians cannot modify the

wire, otherwise it is vulnerable to injury the device or the person.

The following security rules should be followed when using the robotic arm for industrial

design and manufacture.

 You should comply with local laws and regulations when operating the robotic arm. The

security precautions in this document are only supplemental to local laws and regulations.

 The DANGER, WARNING, and NOTICE marks in this document are only

supplemental to the security precautions.

 Please use the robotic arm in the specified environment scope. If not, exceeding the

specifications and load conditions will shorten the service life of the product even damage

the equipment.

 Please ensure that the robotic arm is operated under security conditions and there is no

harmful object around the robotic arm.

 The hazardous area of the robotic arm is its workspace plus 100mm. In order to prevent

people from entering the work area accidentally, it is necessary to build the safety barrier

to prohibit people from entering the hazardous area.

 When the temperature is close to the freezing temperature, the other operations on the

robotic arm will not be allowed until the robotic arm moves at the rate of 10% or less for

more than ten minutes to make itself warm up.

 Highly corrosive cleaning is not suited to cleaning the robotic arm. The anodized

components are not suitable for immersion cleaning.

 Please execute daily inspection and regular maintenance, replace the defective parts in

time, in order to keep the equipment in working order.

 Please comply with the relevant laws to deal with the product which is scrapped, and

protect the environment.