User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
58
Click the icon of Motor on the Operation Panel page, and jog Dobot
M1 by hand.
NOTICE
If you want to jog Dobot M1 by hand when implementing jogging, please click
to make the motor of Dobot M1 in the open-loop state. If you want to
move Dobot M1 by clicking the coordinate buttons on the Operation Panel page,
please click to make the motor in the close-loop state.
If an axis is limited or a point is at the singular position when implementing jogging,
an alarm will be generated. For details about alarm description, please see Table
6.2 .If you save a point after an alarm is generated, the saved point is unavailable.
You need to jog Dobot M1 to clear the alarm, and then save the point again.
However, if an alarm about singular point is generated when implementing jogging,
the saved point is available in JUMP and MOVJ mode.
The Playback page is displayed.
NOTE
The motion mode in this topic is for reference only. You can choose other motion modes
based on site requirements. If you use ARC mode, for details on how to saving points in
ARC, please see 6.1.3 Saving Point in ARC Mode.
Figure 6.5 Choose motion mode