User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 5 Installation and Commissioning
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
42
Debugging the Power of Dobot M1
Prerequisites
You have powered on Dobot M1.
You have connected Dobot M1 and an emergency stop switch.
Procedure
Hold down the power button in the base of Dobot M1 for about 5 seconds, and then release
your fingers. If all LED indicators are off and Dobot M1 moves down automatically, Dobot M1 is
powered off successfully.
NOTICE
You cannot hold down the power button to power off Dobot M1 until Dobot M1 is in the
running state (when the green LED indicator is blinking). If Dobot M1 fails to be started,
you must force to power off Dobot M1.
Setting IP Address
Prerequisites
You have started M1Studio.
You have connected Dobot M1 to the PC over a serial cable.
You have connected Dobot M1 to the PC over a network cable.
You have powered on Dobot M1.
You have connected Dobot M1 and an emergency stop switch.
5.5.3.1 Checking the IP Address of Dobot M1
If Connect turns to Disconnect, the connection is successful.
The Dobot M1 IP Address Setting is displayed.