User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 3 Hardware Installation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
19
Press down the lever on the extruder by hand, and push down the filament to the
bottom via pulley, as shown in Figure 3.7 and Figure 3.8.
Figure 3.7 Push down the filament (1)
Figure 3.8 Push down the filament (2)
(Optional) Installing Air Pump
It is necessary to install the matching air pump when using the gripper or suction cup for
grabbing objects. The air pump is controlled over the I/O interface. For details, please see 6.7
Operating I/O Assistant. The Air pump that we provided is used for debugging I/O interface.
In real applications, please select a professional one.