User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 7 Maintenance
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
95
Figure 7.4 Location of battery holder
Figure 7.5 Disconnect the connector of the battery to the battery adaptor cable
If a fuse is not installed on the battery, please remove the cover of battery holder
to take out the original battery and detach the battery connector of bus cable
connecting to the battery holder, as shown in Figure 7.6.