Use and Care Manual

SE-0304 BAG PROTECTOR ALERT
Protect any bag or valuable with this motion sensor alarm
BATTERY INSTALLATION:
y Loosen the screw and open the battery cover.
y Follow the polarity instructions to install 2 x CR2032 lithium batteries (included).
y Replace the battery cover and tighten the screw.
HOW TO SET THE PERSONAL CODE:
y After installing 2 x CR2032 batteries, the red LED light will flash continuously.
y Choose a 4-digit code and enter it. DO NOT include “S” in your code. ONLY use digits 1, 2, and 3.
y After pressing the selected 4-digit code, 4 beeps will sound and the red LED light will stop flashing. At this point the
code has been successfully set. There are 81 possible codes.
HOW TO CHANGE/UNSET THE PERSONAL CODE :
y Make sure the alarm is disarmed.
y Press “S” and the current 4-digit code.
y You will see the red LED light flash continuously.
y Press a new 4-digit code and 4 long beeps will sound to indicate that the new 4-digit code is successfully set.
y If the new 4-digit code is not keyed-in within 5 seconds, it will not be successfully set and you will need to restart the
change/unset code process again.
HOW TO ARM/DISARM THE ALARM:
y Press “S” twice and you will see the red LED light flash for 5 seconds. The Alarm will then be ARMED.
y If you press “S” & the correct 4-digit code, you will hear 3 beeps indicating that the Alarm has been disarmed
successfully.
y If the incorrect code is keyed-in, 2 brief warning beeps will sound. At this point, you can enter the correct 4-digit code
without pressing “S”.
HOW TO USE THE ALARM:
y After arming the alarm, the unit will be able to detect vibrations and/or movements of your belongings. A “Beep-Beep”
sound will alert users that someone is moving the alarm. If the vibration/movement stops within the next 3 seconds, the
unit will return to ARMED mode.
y If the unit continuously detects two or more vibrations/movements within that same 3 second period, the alarm will
sound for 20 seconds.
y Follow the above instructions to DISARM the alarm.
HOW TO USE AS AN EMERGENCY ALARM:
y Pull out the pull-pin at the top of the unit. The alarm will be activated immediately.
y Re-insert the ripcord and the alarm will stop.
y The Emergency Alarm function can be triggered at any time.
NOTES:
y While in DISARMED mode, one beep every 20 seconds indicates that the battery is weak and should be replaced.
y You must enter the code within the 5-second time limit or the alarm will automatically revert to the preexisting code.
y If your 4-digit code is incorrectly keyed-in 3 times in a row, the alarm will sound automatically.
y When pressing buttons on the Alarm, a beep must be audible after each button selection. If a beep is not heard, the
button has not been properly entered.
y While this is a water resistant product, it is NOT to be used in the rain, underwater, or in extremely wet conditions.
y
Ensure the unit has good battery power to operate as a security guard. Check its power level periodically.
WARNING:
The high pitched alarm sound may injure hearing if in close proximity to the ears. This alarm contains small parts and is not
suitable for children.
QUICK ALARM GUIDE:
Set Code: S + 4-digit code
Reset Code: 1. S + original 4-digit code
2. Key in new 4-digit code within short period time
To Activate the Alarm: S + S
To Deactivate the Alarm: S + correct 4-digit code
Low Battery Indicator: Beeps at each 20-second interval