User Manual

20
ACCESSORIES
The following are accessories sometimes
used during sawing operations. A DoALL
sales representative will be happy to advise
you about the current availability of any ac-
cessory.
DISC CUTTER
1. This attachment can be used to cut internal or ex-
ternal circles from 2-1/2 to 30 inches (63.5 to 762.0
mm) in diameter. To set up the disc cutter:
• Place at washers under the mounting screws.
Then: (a) Bolt the mounting bracket to the post;
(b) Lower the post until the upper saw guide is ap-
proximately 3/8 inch (10 mm) above the worktable;
(c) Loosen the ne adjustment and arm clamp bolts;
(d) Move the center pin to the approximate distance
of the radius to be cut; (e) Tighten the ne adjust-
ment clamp bolt.
Disc Cutter.
• Position the center pin so that it is perpendicular to
the saw band's cutting edge. To do so: (a) Place
a square against the tip of a sawband tooth; (b)
Loosen the vertical adjustment clamp bolt; (c) Line
up the center pin with the square's blade edge; (d)
Clamp the vertical adjustment clamp bolt.
• Make nal radius adjustments with the ne adjust-
ment wheel. Then: (a) tighten the arm and radius
arm clamp bolts while making sure the center pin
is square to the table; (b) Adjust the disc cutter for
stock thickness by raising or lowering the post.
MITER NO. 2 CUT-OFF (Side Mount)
1. To set up: (a) Place a combination square in the
worktable sawing slot to check the alignment; (b)
Set the bar for sawing at the desired angle. It is im-
portant that the mitering bar contact the worktable's
surface evenly during use.
Miter No. 2 Cut-Off Option.
2. When not in use, this unit can be swung upward
and around on the slide rod so that it hangs down
below the worktable surface.
RIP FENCE
1. Square this xture during installation so that it is in
line with the worktable sawing slot. When alignment
is correct, secure the adjusting screws in place with
the set screws under the the guide bar on the rip
fence casting.
2. Before attempting a long cut, check to see that the
saw band is not worn on one side. This will cause
stock to wander relative to the rip fence guide bar.
Rip Fence.
HEAVY WORK SLIDES
1. This unit features metal ball bearing slide bars po-
sitioned to reduce friction between the worktable
and heavy stockpieces.