User Manual

17
3. Keep the mist applicator nozzle and lter clean.
If the center nylon coolant tube needs replacing,
remove the entire applicator tube. Insert new nylon
tube and trim off excess ush with nozzle. Make
sure all joints are sealed and tight after applicator
tube is reinstalled.
MACHINE CLEANING
Stop the machine when cleaning the machine
or opening bandwheel doors or covers.
1. Keep the machine and its parts as clean as possible
to prevent excessive wear and damage.
2. Remove the chip pan and dispose of the chips when
necessary.
3. Metal chips and other waste materials may
collect around areas such as: saw guides,
table surface, T-slots, bandwheels, slides, etc.
Remove these materials as soon as possible. The
DoALL Company recommends removing chip
collections at least twice per each eight (8) hour
shift, and more often with heavier use.
MIST COOLANT (Continued....)