User Manual
25
LASER LINE GENERATOR OPTION
To avoid eye damage, DO NOT stare into the
laser beam.
1. A laser devise is used to emit a line on the material
to be cut. This line shows the approximate spot
where the cut will take place.
2. The devise is controlled by a selector switch with
"ON" and "OFF" settings and is located on or near
the control panel. Turn the laser "OFF" when not
in use.
3. The laser is adjustable to position the laser beam
where desirable.
4. When the laser is turned on, a warm-up period of
3 to 5 seconds take place before a line appears. If
the line is difcult to see, darken the work area to
enhance the line.
5. Remove the protective shipping cap from the laser
devise before operation. Replace the protective
cap when not in use.