User Manual

21
ACCESSORIES
The following are accessories sometimes
used during contour sawing operations. A
DoALL Sales representative will be happy to
advise you about the current availability of
any accessory.
DISC CUTTER
1. This attachment can be used to cut internal or
external circles from 2.50 to 30 inches (63.5 to 760.2
mm) in diameter. To set up the disc cutter:
• Place at washers under the mounting screws.
Then: (a) Bolt the mounting bracket to the post;
(b) Lower the post until the upper saw guide
is approximately 3/8 inch (9.5 mm) above the
worktable; (c) Loosen the ne adjustment and
arm clamp bolts; (d) Move the center pin to the
approximate distance of the radius to be cut; (e)
Tighten the ne adjustment clamp bolt.
Disc Cutter.
• Position the center pin so that it is perpendicular to
the saw band's cutting edge. To do so: (a) Place
a square against the tip of a sawband tooth; (b)
Loosen the vertical adjustment clamp bolt; (c) Line
up the center pin with the square's blade edge; (d)
Clamp the vertical adjustment clamp bolt.
• Make final radius adjustments with the fine
adjustment wheel. Then: (a) tighten the arm and
radius arm clamp bolts while making sure the center
pin is square to the table; (b) Adjust the disc cutter
for stock thickness by raising or lowering the post.
UNIVERSAL CALIBRATED WORK FIXTURE
Set-Up for Straight Cut-Off
1. Place the xture on the worktable at the required
distance from the saw band. Then: (a) Loosely
install T-nuts and screws; (b) If necessary, align
the scale's zero (0) mark with the saw band, then
"zero" the pointer.
2. Place socket head screws loosely in the T-nuts
projecting up from below the back-up bar. Then:
(a) Place the T-nuts in the worktable T-slots; (b)
Slide the work xture's back-up edge to a distance
equal to the desired length of cut. Be sure to allow
enough clearance for positioning the stock.
3. Square the back-up bar to the worktable by aligning
one (1) movable workstop edge with the T-slot or
edge of the table sawing slot. Then: (a) Line up
the calibrated bar's "0" mark with the saw band; (b)
Tighten the socket head screws so that the back-up
bar is rmly anchored to the worktable.
Universal Calibrated Work Fixture Set-Up for Straight Cut-Off.
4. Shift the movable workstop to one side of the saw
band. Then: (a) Run the worktable forward until
the front of the workstop passes the saw band; (b)
Move the workstop toward the saw band until its
edge barely touches the set teeth.
5. Close the locking lever to hold the workstop in
position. Then adjust the workstop pointer until it
lines up with the scale's "0" mark.
Set-Up for Angle Cut-Off
1. Loosen the left socket head screw. Next: (a)
Remove the right T-nut and screw from the back-up
bar; (b) Use a protractor or square to position the
back-up bar at the desired angle as measured to
the worktable's T-slot; (c) Tighten the socket head
screw.