User Manual

11
POST ADJUSTMENT
1. Post and upper saw guide elevation can be adjusted
to accept workpieces with heights varying up to 12
inches (304.8 mm) (standard work height) by means
of a handwheel located on the right side of the saw
head.
2. Post and upper saw guide can be adjusted by
turning the handwheel clockwise to "raise" the post
and upper saw guide, counterclockwise to "lower"
them.
3. Always keep the post and upper saw guide as close
as possible to the workpiece and the band guard in
place at all times while sawing.
WORKTABLE AND TILT ADJUSTMENT
1. The standard hydraulically powered worktable
measures 27.0 by 34.0 inches (685.8 by 863.6 mm)
with a table stroke of 12 inches (304.8 mm). Table
controls are mounted on the front column and has
feed range of 0 to 6 fpm (0 to 1.8 m/min.). Its load
capacity is 500 pounds (226.8 kg).
 Themachinemustbeboltedtotheoorfor
table loads over 100 pounds (45.4 kg).
2. The worktable is drilled and tapped on the right
side to attach accessory equipment. Its removable
center plate can be replaced with optional plates
for various options. The worktable also has two (2)
1/2 inch (12.7 mm) wide T-slots for tool and xture
mounting purposes.
Hydraulically Powered Worktable.
3. Two (2) adjustable work stops, located on the table's
left side, limit table travel. The front stop controls
the cut depth, the rear stop minimizes unnecessary
table travel. They can be adjusted by loosening the
lock nuts and slide the work stops to the desired
position.
4. The worktable can be tilted manually up to 10º left
and 45º right primarily for sawing compound angles.
The amount of worktable tilt is indicated by a pointer
and a trunnion-mounted calibrated scale.
5. To tilt the worktable: (a) Use the wrench provided
to reach through the machine frame and under
the worktable to loosen the tilt locknut; (b) Tilt
the worktable manually until the pointer reaches
desired angle shown on the scale; (c) Tighten the
tilt locknut.
MIST COOLANT
1. Mist coolant uses plant air, a valve with sight glass
and a one (1) quart (0.95 liter) supply bottle mounted
on the rear side of the head.
Typical Mist Coolant.
2. Air and coolant are mixed in a manifold to form a ne
mist. Adjust the exible tube to direct mist stream
onto saw band and workpiece. Regulate mist with
adjustable valve at a rate of one drop per second
as seen through the sight glass.
3. Your DoALL Sales representative can provide
complete information on various coolants.
WHEEL BRUSH AND CHIP REMOVAL
1. A brush located on the lower bandwheel
approximately in the ten (10) o'clock position cleans
metal chips from the bandwheel during machine
operation. Removed chips drop into a removable
pan in the machine base. This pan should be
emptied periodically.