User Manual

22
3. Square the back-up bar to the worktable by aligning
one (1) movable workstop edge with the T-slot or
edge of the table sawing slot. Then: (a) Line up
the calibrated bar's "0" mark with the saw band; (b)
Tighten the socket head screws so that the back-up
bar is rmly anchored to the worktable.
Universal Calibrated Work Fixture Set-UP for Straight Cut-Off.
4. Shift the movable workstop to one side of the saw
band. Then: (a) Run the worktable forward until
the front of the workstop passes the saw band; (b)
Move the workstop toward the saw band until its
edge barely touches the set teeth.
5. Close the locking lever to hold the workstop in
position. Then adjust the workstop pointer until it
lines up with the scale's "0" mark.
Set-Up for Angle Cut-Off
1. Loosen the left socket head screw. Next: (a)
Remove the right T-nut and screw from the back-up
bar; (b) Use a protractor or square to position the
back-up bar at the desired angle as measured to
the worktable's T-slot; (c) Tighten the socket head
screw.
Universal Calibrated Work Fixture Set-UP for Angle Cut-Off.
2. Mount the collar on the right T-nut and fasten it to the
worktable (against the back-up bar) with the socket
head screw. Then: (a) Run the worktable forward
until the back-up bar barely touches the saw band;
(b) Set the workstop for the required stock length
dimension. The back-up bar scale is not used
for angle cuts.
3. Notch the back-up bar with the saw band to assure
being able to cut completely through the stock. Set
the worktable stop to limit travel to the length of
cut.
PROTRACTOR WORKSTOP and ALIGNMENT
GAGE (Used with Air Table Option)
1. To set up this unit: (a) Lock the slide bar into the
worktable T-slot so that the miter head clears the
saw band; (b) Release the clamping handle to
adjust the miter head for angle cutting between 0°
and 45°.
Protractor Workstop and Alignment Gage.
2. Adjust for the desired cut length by loosening the
gage rod thumb screw. Then: (a) Slide the rod to
the desired position; and (b) Tighten the thumb
screw.
2. Set-up by clamping the vise jaws into the worktable's
right T-slot and the cut-off gage into the left T-slot.
DBW-15 BUTTWELDER
1. Information covering blade welding, plus operation
and maintenance of the optional DBW-15 Buttwelder
(with ash grinder and blade shear) are provided in
a seperate instruction manual.
UNIVERSAL CALIBRATED WORK FIXTURE
(Continued....)