User Manual
15
2. To replace the belt: (a) Loosen the screws that
mount the drive motor and slide the motor to the
left; (b) Slip the old belt from the pulleys and install
the new one; (c) Slide the drive motor to the right
to tighten the belt so there is very little deection of
the belt; (d) When correct belt tension is acheived,
tighten the screws.
MIST COOLANT
1. Intermittent coolant stream indicates an air leak.
Check all joints.
2. Clogging may occur if waxed-based or other
coolants are used. Your DoALL sales representative
can provide complete information about various
coolants.
3. Keep the mist applicator nozzle and lter clean.
If the center nylon coolant tube needs replacing,
remove the entire applicator tube. Insert new nylon
tube and trim off excess ush with nozzle. Make
sure all joints are sealed and tight after applicator
tube is reinstalled.
BAND DRIVE BELT (Continued....)