User Manual

12
LUBRICATION
LUBRICATION CHART
LOCATION DESCRIPTION AND
SERVICE RECOMMENDATIONS
RECOMMENDED
LUBRICANT
LUBRICATION
INTERVAL*
LUBRICATION
POINT NO.
High quality, EP (extreme pressure),miulti-
purpose gear oil.
S.A.E. Grade No. 90
Union 76, MP Gear Lube 90, or equivalent.
5
Lubricate (if any) per manufacturer's recommendations.
Micellaneous: Slides, Hinges, Pivot Points,
Component Parts, unpainted Surfaces, etc. Clean and
apply oil as required.
High quality, rust and oxidation-inhibited,
medium hydraulic and general purpose
industrial oil.
ISO-VG Grade 68 (Formerly ASTM Grade
No. 315).
Union 76, UNAX RX 68, or equivalent.
* Lubrication intervals are based on a 8-hour day, 40-hour week.
Lubricate more often with heavier use.
1
Band Tension Screw and Bearing. Clean and apply oil.
MONTHLY
2
Post. Clean and apply oil.
MONTHLY
3
Upper Bandwheel Slide, Hinge and Tilt Screw. Clean
and apply oil.
MONTHLY
4
Table Trunnion. Oil tilt surfaces.
MONTHLY
CHECK
MONTHLY
6
Accessory Equipment When Supplied. Keep clean and
apply oil as required to maintain proper function, reduce
wear and corrosion, etc.
CHECK
MONTHLY
CHECK
MONTHLY
7
Transmission. One (1) quart (0.95 liter) capacity. Proper
oil level must be maintained. Drain and rell yearly or
when required.
8
Electric Motor. Drive.
Lubricate as required per DBW-15 Instruction Manual.
11
DBW-15 Buttwelder (Optional).
CHECK DAILY/
AS REQUIRED
9
Mist Coolant Reservoir (Optional). One (1) quart (0.95
liter) capacity. Keep lled and hoses clear.
Premium quality, saw band coolant and
lubricant.
DoALL cutting uids and/or oils (AL-2000).
Contact your DoALL sales representative
for the best oils and/or uids for your
application.
DoALL cutting uids and/or oils.
CHECK DAILY/
AS REQUIRED
Band Mist Lubricator (Optional). Sixteen (16) ounces
(0.95 liter) capacity. Keep lled and hoses clear.
10