User Manual

4
INSTALLATION
All the “left”, “right”, “front” and “rear”
designations in this manual are as viewed by
the operator facing the machine controls on
the electrical control box.
LOCATION
1. The oor area required by the standard machine is
approximately 55 inches (1399.0 mm) in width by
44.5 inches (1130.3 mm) in length. Machine height
for the standard machine is 80.17 inches (2036.3
mm). Refer to pages 1 & 2 for further machine
dimensions.
2. Locate the machine to provide adequate space for
your sawing needs. Be sure to provide sufcient
clearance for: (a) Material loading and unloading; (b)
All door openings; (c) Maintenance and lubrication
procedures; (d) Operation of the any supplied
machine accessories.
OSHA NOTICE!!
OSHA Regulation 1910.212 (5B).
 Machinesdesignedforaxedlocationshall
be securely anchored to prevent walking or
moving.
UNPACKING
1. The machine is fastened to and shipped on a wooden
skid. Overseas shipments are also crated.
2. Carefully remove all protective covers, strapping,
hold-down brackets, crating, etc. Then: (a) Remove
all bolts which fasten the machine to the shipping
skid; (b) Check inside the rear drive compartment
for other removable brackets, extra machine parts
or supplies which might have been placed there for
shipment; (c) Remove the blocking from under the
drive motor plate; (d) Inspect the machine and all
parts for shipping damage. Claim procedures are
listed on this manual’s inside front cover.
CLEANING
1. If necessary, use solvent to remove rust-preventive
coating applied to exposed bare metal surfaces
before shipment.
LIFTING
1. A tapped hole is located on top of the machine's saw
head. Screw a forged 3/4-10NC eye-bolt into this
hole for lifting purposes. Net weight of the machine
is approximately 1250 pounds (567.0 kg).
DO NOT lift the machine by its sawing head.
MACHINE ALIGNMENT
To properly align the machine:
1. Place shims between the oor and the base mounting
pads until the machine is level with weight resting
evenly on all the base pads.
Shim Locations.
2. Square the worktable to the side of the post by
loosening the tilt lock bolt located in the machine's
frame under the worktable and make the necessary
adjustments. If necessary: (a) Position the
worktable's tilt angle pointer at zero (0) on the tilt
scale; (b) Tighten the tilt lock bolt.
Squaring Worktable to Post.