User Manual
20
MAGNIFIER
1. Magnifing the cutting area may prove helpful
during delicate sawing procedures. This is done
by placing a magning lens around the shade of
the worklight.
2 . A protective lens cover should be placed around
the magnier to prevent scratches when not being
used.
POST ELEVATING HANDWHEEL
1. This option allows the operator to adjust the post
and upper saw guide by means of a handwheel
located on the right side of the sawing head. Turn
the handwheel clockwise to "raise" the post,
counterclockwise to "lower" it.
WORKTABLE OPTIONS
30" x 30" Worktable
1. Your machine may be equipped with a factory-
installed 30 x 30 inch (762.0 x 762.0 mm) worktable
in place of the standard 26 x 26 inch (660.4 x 660.4
mm) worktable. Load capacity is 500 pounds (226.8
kg).
18" Stroke Worktable
1. This factory-installed air-powered worktable has a
18 inch (457.2 mm) stroke instead of standard 12
inch (304.8 mm) stroke. The table's working surface
is 24 by 36.5 inches (609.6 by 927.1 mm).
Glide Table
1. This worktable option has a 26 by 26 inch (660.4
by 660.4 mm) worktable and table travel of 10-3/4
inches (273.0 mm). It can not be tilted. Load
capacity is 200 pounds (90.7 kg).
2. The workpiece is securely clamped to the table.
The operator then holds the handle in front of
the table and manually pushes the table with the
workpiece through the saw band. The handle also
acts as a workstop if desired.
DO NOT force workpiece through the saw
band.
3. A thumbscrew located in the lower right under
the worktable locks the worktable in place to
allow loading and unloading of stock. Loosen the
thumbscrew completely for the worktable to move
freely.
CHIP BLOWER
1. The operator can remove chips from the sawing
area by using the chip blower. Shop air is used to
deliver air to the cutting area.
2. Adjust the exible hose and nozzle to direct chips
away from the sawing area.
3. The air supply connection is located on the left
side of the machine on the drive compartment wall.
Incoming air supply should be between 80 and 90
psi (5.6 and 6.3 kg/cm²).
DO NOT exceed 90 psi (6.3 kg/cm²).
MIST COOLANT
1. Using shop air, this option has a valve with sight
glass and a one (1) quart (0.95 liter) supply bottle
mounted on the rear side of the head.
2. Air and coolant are mixed in a manifold to form a ne
mist. Adjust the exible tube to direct mist stream
onto saw band and workpiece to lubricate and cool
the cutting area. Regulate mist with adjustable
valve at a rate of one drop per second as seen
through the sight glass.
3. The air supply connection is located on the left
side of the machine on the drive compartment wall.
Incoming air supply should be between 80 and 90
psi (5.6 and 6.3 kg/cm²).
DO NOT exceed 90 psi (6.3 kg/cm²).
4. There is a ball valve at the air connection to turn
the supplied air on and off if necessary.
5. Your DoALL sales representative can provide
complete information on various coolants.
BAND MIST LUBRICATOR
1. See the instructions sent with the unit for information
on operation and adjustments.
WORKLIGHT
1. The worklight illuminates the cutting area and areas
nearby and is controlled by an "on/off" switch on the
lamp, or by selector switch on the electrical control
box.