User Manual

OPERATION

SAFETY PRECAUTIONS

Warning Label - READ and UNDERSTAND.

USING THE JOB SELECTOR

1. Refer to the Job Selector chart located on the

upper bandwheel door. It has information about the

recommended band type and pitch, band speeds

and cutting rates according to the type of material

to be cut and its thickness. It also has a radius

guide that shows the minimum radii cuts possible

with various saw band widths.

2. To use, nd the material to be cut in the rst column.

Then move to the right to nd information on coolant

application if any, band speed recommendations,

feed rates and band type and pitch.

The Job Selector is a guide only and the

recommendations shown can be adjusted to

meet special material requirements.

Job Selector.