Wireless Charger user manual Wireless Charger Power Bank Model：WD-E01A
Contents 1.What is in the box 2.Product Introduction 3.Specification 4.How to use 5.Important Notification 6.FCC Statement & Warning 7.Trademark Acknowledgments Thanks for purchasing this fantastic Qi Wireless charger. Please read the manual in detail for proper operation before you get to start to use. Manufacturer: SHENZHEN DNS INDUSTRIES CO., LTD. Address:23/F Building A, Shenzhen International Innovation Center, No.
Specification Features: Main functions: single coil wireless charger transmitter; Products applicable: all wireless charging equipment accorded with Qi standard; Charging type: one-on-one charge corresponding area; Fast charging model only work with QC quick charger. Specification: Main functions: single coil wireless charger transmitter; Standard version: WPC - 1.2.
How to USE 1, Plug Your Qi Wireless Charger to the Power Source Plug the small end (micro USB B port) of the USB cord into the side of the Qi charger.
status, the green light goes out. 2) Please lay the device directly on wireless charger for charging, the green light always stays on when the charger is in charging status 3) When the device is full of power, the green light goes out. 4) The transmitter has the function of detecting foreign objects(FOD). If there is a foreign object on the transmitter, the green light will flash.
B .
This equipment has been tested and found to comply with the limits for a WPC device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a wireless power charger, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
