Instruction manual

DNP IMS America Corp. 13

Printer Properties Software Update Procedure

ICM Method

ICM Intent

This designates the rendering method when using ICM. Always have the ICC profile for the DS40 set to Picture.

Do not use other settings.

Advanced Printing Features

Always have this set to Enabled. Do not use other settings.

Pages per Sheet Layout

If Pages per Sheet setting is “multiple pages per sheet,” the layout direction of a picture is specified.

Border

This setting is synchronous with the border option in the Paper tab.

Overcoat Finish

You can choose an overcoat finish for the printed surface from the following two types:

Note

Depending on the version being used, “Glossy” may be the only finish option.

Print Retry

If printer errors, the setting in Print Re-try will determine if data in the printer buffer will print after error recovery.

According to the contents of a printer error, the power supply of the printer may need to be re-switched on for error

recovery. In this case, it is not dependant on the setup of Print Re-try, and printing data in a printer buffer is cleared.

2inch cut

In the case of a specific paper size of DS40, it sets up whether the printer cuts into two or more sheets in 2” length.

ICM Method Function

ICM Disabled Synchronous with “Color Management: None” in Paper tab.

ICM Handled by Host System Synchronous with “Color Management: ICM” in Paper tab.

Performs color management with the driver

ICM Handled by Printer This is the same setting as “ICM Handled by Host System”

Overcoat Finish Function

Glossy This finishes the print with a glossy surface.

Matte This finishes the print with a matte (non-glossy) surface.

Print Re-try Function

Disable Printing data in the buffer is cleared after printer error.

After an error recovery, the cleared image data must be resent.

Enable Printing data in the buffer is held after printer error.

After an error recovery, the print process resumes with the saved data in the buffer.