Operating instructions

41
Specifications
Appendix
Specifications
Power requirements
100 to 240 V AC, 50/60 Hz
Input current 1.6 to 0.8 A max.
Operating temperature range
10°C to 35°C (50°F to 95°F)
Operating humidity range
20% to 80% (no condensation)
External dimensions
Approx. 203 × 85 × 305 mm (WHD)
(8 × 3
3
/
8
× 12
1
/
8
inches)
(excluding the maximum projecting
parts)
Mass Approx. 2.7 kg (5 lb. 15 oz.)
(printer only)
Printing system Dye sublimation thermal transfer
Resolution 403 dpi
Gradations 8 bits (256 levels) each for Yellow,
Magenta, Cyan
Print size UPC-X34 series:
70 × 95 mm ±2 mm (2
7
/
8
× 3
3
/
4
inches ±
3
/
32
inches)
UPC-X46 series:
102 × 152 mm ±2 mm (4
1
/
8
×
6 inches ±
3
/
32
inches)
Printable pixels UPC-X34 series:
1,112 × 1,512 dots
UPC-X46 series:
1,664 × 2,440 dots
(The top and bottom and right and left
portions will not be printed by about
2 mm)
Printing time UPC-X34 series: Approx. 65 sec.
UPC-X46 series: Approx. 100 sec.
(Printing time may vary depending on the
conditions of use.)
Input connector AC IN (for power)
USB function port
Hi-Speed USB (USB2.0)
USB host port for the USB memory (1)
Memory card slots
SD Card interface slot (1)
(SDXC not supported)
Compatible image file formats
DCF 2.0 compatible image files
• JPEG: JFIF 4:4:4, 4:2:2, 4:2:0 (baseline
JPEG)
Exif 2.2.1 compatible (progressive
JPEG and 8-bit grayscale JPEG not
supported)
• TIFF: Exif 2.2.1 compatible (RGB non-
compressed)
NO IMAGE DATA Printable image files cannot be
found on the storage media when
trying to print from storage media.
Printable data does not exist on
the internal memory when trying
to perform copy print.
NO ID PHOTO DATA
SELECT ID PHOTO
Data for the specified ID photo
layout cannot be found.
 Reselect the ID photo layout
(page 18).
 Check that the ID photo layout
exists on the expansion SD
card.
 Insert the expansion SD card
on which the ID photo layout is
stored.
NO FACE DETECTED A face was not properly detected
during passport printing with the
auto alignment trimming function
enabled.
 Check the photo that was
taken.
 Turn OFF the auto alignment
function for trimming, and
shoot and print the photo again
(page 19).
IMAGE DATA ERROR Images cannot be read properly.
 If you are printing from storage
media, check the image files
on the storage media.
 Check whether the format of
the image file is supported by
this unit (page 7).
 Data transfer errors may occur
due to the effects of magnetic
or electro magnetic waves from
microwave ovens or wireless
devices (e.g., IEEE802.11b/g/
n, Bluetooth, or specified low
power radio devices). Check
your usage environment.
 The wireless LAN SD cards
may be malfunctioning. Try
formatting the wireless LAN SD
cards (page 22).
Display Cause/remedy