Operating instructions

40
Troubleshooting
Appendix
Error Messages
Images cannot be
transferred.
If the unit and the digital camera
are out of range or the signal is
weak, the transfer rate may drop,
increasing the transfer time, or
connection may not be
established.
 Close the distance between the
unit and the digital camera until
the signal is in range.
 Do not block the wireless LAN
SD card slot areas with your
hands or other objects.
 The transfer rate may drop or
connection may not be
established due to the effects
of magnetic or electro magnetic
waves from microwave ovens
or wireless devices (e.g.,
IEEE802.11b/g/n, Bluetooth, or
specified low power radio
devices). Check your usage
environment.
The connection was severed from
the other device.
 Check the power status and
other conditions on the digital
camera, and establish
connection again. We
recommend disabling the
power saving function on the
digital camera (page 26).
The remaining capacity on the
wireless LAN SD card is
insufficient.
 Back up the wireless LAN SD
card data, and increase its
remaining capacity.
The unit does not print. A print mark (DPOF) for an image
that has already been printed
remains.
 Cancel all the print marks
(DPOF) on the digital camera,
and specify print marks again
(page 29).
Menu operations on the unit are in
progress.
 Close any menus, and check
that [READY] appears on the
LCD display.
“IMAGE DATA ERROR”
appears on the LCD
display, noise-like lines
appear in printed
photos, or similar errors
occur.
 Data transfer errors may occur
due to the effects of magnetic
or electro magnetic waves from
microwave ovens or wireless
devices (e.g., IEEE802.11b/g/
n, Bluetooth, or specified low
power radio devices). Check
your usage environment.
 The wireless LAN SD cards
may be malfunctioning. Try
formatting the wireless LAN SD
cards (page 22).
Symptom Cause/remedy
Display Cause/remedy
SET NEW RIBBON
PUSH [EXEC]
The print cartridge is not inserted
properly.
 Insert the print cartridge
properly, and press the EXEC
button.
The print cartridge has run out.
 Replace the print cartridge,
and press the EXEC button.
SET PAPER
PUSH [EXEC]
The paper tray is not inserted.
 Insert the paper tray, and press
the EXEC button.
The print paper has run out.
 Insert more print paper, and
press the EXEC button.
The paper is not feeding.
 Remove the paper tray, and
reinsert it.
MEDIA MISMATCH
PUSH [EXEC]
The print paper and print cartridge
are mismatched.
 Insert the correct print paper,
and press the EXEC button.
A print cartridge of a different size
from the cartridge inserted before
the error was inserted after the
error.
 After an error occurs, be sure
that the inserted print cartridge
is the same size as the
cartridge from before the error.
PAPER JAMMING
REMOVE PRINTS
A paper jam has occurred.
 Remove the jammed paper,
and try printing again
(page 15).
REMOVE PRINTS
PUSH [EXEC]
Print paper remains in the paper
eject outlet.
 Remove the paper tray and
remove the print paper, and
press the EXEC button.
PRINTER ERROR
PLEASE RETRY
A printer error has occurred.
 Restart the unit, and try
printing again.
CARD FULL
PUSH [EXEC]
The storage media is full.
 Insert storage media with
sufficient remaining capacity,
and press the EXEC button.
CARD LOCKED
PUSH [EXEC]
The SD card is write-protected.
 Reinsert the SD card after
setting it to write-enabled, and
press the EXEC button.
CARD ERROR
PUSH [EXEC]
Data cannot be written properly to
the storage media.
 Reinsert the storage media
after checking that it is
functioning normally, and press
the EXEC button.