Operating instructions

25
Shooting Preparation
Chapter 4 Operation
Three sizes of guideline stickers are supplied: 69 mm
(2.7"), 71 mm (2.8"), and 76 mm (3.0"). Use the sticker
size that matches the size of the monitor on your digital
camera. (The S mark on the sticker sheet indicates the top
of the sticker.)
Inserting the wireless LAN SD card
Insert the supplied wireless LAN SD cards into the printer
(this unit) and your digital camera.
The unit is supplied with one wireless LAN SD card for
use with a digital camera and one for use with the printer.
The cards for the digital camera and printer are labeled “C”
and “P” respectively. Insert the respective cards into the
SD card slots on the digital camera and the printer.
The unit is shipped with the wireless LAN SD card for the
printer already inserted in its SD card slot.
Wireless connection
After inserting the wireless LAN SD cards, the wireless
connection will be established automatically when the unit
and the digital camera are turned on. The connection takes
about 30 seconds to establish after the power is turned on.
However, connection may take longer depending on the
signal conditions.
When proper wireless connection is established, the
following antenna icon appears under [READY] on the
unit’s LCD display. If another display (e.g., a layout name)
appears under [READY] instead of the antenna icon, press
S or T on the control button to change the display.
If wireless network connection is not established, “__” will
appear next to the antenna icon.
• If the wireless connection is not established, try
restarting the unit and digital camera.
• If the unit and the digital camera are out of range, close
the distance between the unit and the digital camera until
the signal is in range (within 5 m (16.4 ft.)).
• If the card for use with the digital camera is inserted in
the printer, or the card for use with the printer is inserted
in the digital camera, proper network connection will not
be possible. Confirm the “P” (card for printer) or “C”
(card for camera) label on each card.
• Do not remove the wireless LAN SD cards while the unit
is turned on.
• If the remaining capacity on the wireless LAN SD card
is insufficient, images cannot be received. Check that the
remaining capacity is sufficient (512 MB or more is
recommended).
The wireless LAN SD cards supplied with the unit come
preconfigured for use with the unit and a digital camera. If
you want to reconfigure the wireless LAN SD card
settings, see “Configuring the Wireless LAN SD Card” on
page 21.
Memo
Notes
Memo