Operating instructions

15
Inserting Storage Media (SD Cards / USB Memory Devices)
Chapter 2 Preparation
Repairing Breaks in the Ink Ribbon
The remaining ribbon can be used after repairing it with
adhesive tape.
1 Remove the print cartridge.
2 Pull the ribbon on the spool, attach one edge of a strip
of adhesive tape along the entire length of the ribbon’s
end, and then attach the other edge of the tape to the
ribbon on the other spool.
3 Remove any slack from the ribbon.
Be sure to wind the taped portion completely so that
the tape is not exposed.
4 Insert the print cartridge into the unit.
Depending on the position of the ribbon break, a single
printout’s worth of ribbon may be lost.
Clearing Paper Jams
If the print paper jams during printing, the status indicator
lights orange, an error message appears, and printing stops.
1 Press the on/standby button to set the unit to standby
mode.
2 Remove the paper tray, and then remove the jammed
paper.
3 Remove the rear cover on the unit, and check for and
remove any remaining pieces of jammed paper.
4 Replace the rear cover.
Always replace the rear cover after clearing paper
jams. The rear cover should always be attached during
normal operation.
5 Insert the paper tray.
6 Turn on the unit.
Inserting Storage Media
(SD Cards / USB Memory
Devices)
Insert and remove storage media only when the unit is in
standby mode and [READY] appears on the LCD display.
Removing the storage media or disconnecting the power
cord while printing is in progress may damage the data
stored on the media.
Before using data on the unit, always create backups to
prevent data loss.
Inserting the storage media
1 Remove the slot cover on the front of the unit.
2 Insert the storage media into the unit.
3 Replace the slot cover.
Depending on the shape of the USB memory device
inserted, the slot cover may not close.
Note
Note
Rear cover Paper
Note