Operating instructions

14
Replacing Print Packs
Chapter 2 Preparation
3 Fully insert the paper tray.
Do not touch the printing surface. Fingerprints or dust
on the printing surface may result in lower printing
quality.
4 When you finish loading the print pack, press the
EXEC button.
The error message on the LCD display will disappear,
and you can perform operations.
• Use the large paper tray when loading UPC-X46 paper,
and the small paper tray when loading UPC-X34 paper.
If the paper size and tray size do not match, paper jams
may occur.
• Do not remove or insert the paper tray during printing.
• If the print paper does not feed automatically, the status
indicator lights orange and a message appears. In such
cases, pull out the paper tray and check for a paper jam.
• When adding print paper to a partially full tray, make
sure that the total number of sheets does not exceed 25
for UPC-X46 paper and 30 for UPC-X34 paper. Do not
place different types of print paper into the tray at the
same time. Doing so may cause paper jams.
• Do not allow more than five sheets of ejected print paper
to accumulate on the paper tray. Doing so may cause
paper jams.
Replacing Print Packs
If the print cartridge or print paper runs out during printing,
the status indicator lights orange and an error message
appears. Perform the following to replace the print pack.
Removing the Print Cartridge
1 Press the PUSH OPEN area at the top of the cartridge
compartment cover to open it.
2 Raise the cartridge release lever.
Remove the print cartridge when it ejects.
3 Insert a new print cartridge, and close the cartridge
compartment cover.
• Never put your hand into the cartridge compartment, as
temperatures inside can get very hot.
• Do not rewind the ink ribbon to reuse it for printing.
Doing so will prevent you from obtaining proper
printing results and may cause malfunctions.
Loading Print Packs
For details on loading print packs, see “Loading Print
Packs” on page 13.
Note
Notes
Notes
Cartridge release
lever