Instruction manual

39
CAUTION
When shipping or moving the printer,
you must set the transport mode. If the printer is not set
the transport mode, it may have a damage.
>Transport mode
OK?
ENTER
EXIT
Please,
Power off
Exit user mode
Press to carry out transport mode.
(The electronic beep sounds.The beep will not
sound if the buzzer mode setting is set to off.)
Please turn off the power.
Turning on the power, then the
transport mode is canceled.
>Download
OK?
Press ENTER key to set DOWNLOAD mode.
ENTER
EXIT
Exit user mode
(The electronic beep sounds, The beep will not
sound if the buzzer mode setting to off)
When data is received from the Host
computer,Downloading will be displayed.
>Downloading
Keep power On
Start
Completion
>Download Ready
>Downloading>
EXIT
Power Off
EXIT
>HR Control
on
EXIT
Exit user
mode.
ENTER
Availability of heat roller control at the re-transfer side.(on,off)
(The electronic beep sounds .The beep will not sound if the buzzer
mode setting is set to off.)
Press to select the setting press to save.
MENU
RESET
ENTER
>>IP Address OK?
000.000.000.000
Enters to setting mode.
000.000.000.000
∗
Use the ↑↓ keys to
change the value of the
digit at the ∗ symbol.
To increase, use ↑ key
To decrease, use ↓ key
000.000.000.000
∗
Use the RESET and MENU
key to change the digit
at the ∗ symbol.
RESET
Use RESET key to
move the * symbol
to the left (← )and
MENU key to move
it to the right (→ )
MENU



192.000.000.000
∗
Move to the digits to be
changeed and use the
↑↓ keys to change
the Value.

192.168.000.001
∗
EXIT
ENTER
>>IP Address OK?
192.168.000.001
MENU
Use the EXIT key to
return to the original
setting
Use the MENU key to
proceed to the next
setting.
>>Subnet Mask
255.255.255.000
If the adress displayed
matches the address you
want to set,pressthe
ENTER key to save.
Input method Address Setting mode
To enter IP Address, Subnet Mask and Default
Gateway using Network Setting from the printer, press
Enter key at each setting screen to go into the Address
Setting mode.
Use the following procedures to set the address.
CAUTION
When data is transferring from thee
host computer, “Downloading” will be displayed
If the power is turned off at this time, the printer firmware
will crash and the printer cannot operate.
Please set ON normally in this mode. When the printer
is set ON in this mode, the printer will become standby
at low temperature of the retransfer heat roller after no
printing motion for 30 minutes and over. The
temperature of the heat roller will automatically get an
original setting when next card printing command
received. For that reason, it takes long time for 1st card
compared with normal printing.
Low temperature stand-by mode setting
Set the printer to DOWNLOAD mode.
DOWNLOAD mode setting
To set the transport mode.
Transport mode