User Manual

DMXking.com • JPK Systems Limited • New Zealand
0106-700-1.1
2
In many LED pixel installations, especially where the majority of pixels may be running simultaneously at full brightness, it is
necessary to inject DC power at various points along the pixel strip or string. Although the LeDMX4 PRO can only provide up to 5A
per output port terminal block this is not a limitation since currents higher than that will require power injection along the strip
anyhow. Contact DMXking technical support for additional advice.
2. CONNECTIONS
LEDMX4 PRO
5V LeDMX4 PRO 12-24V LeDMX4 PRO
 DC Power Input – Supply polarity marked on board. Note supply voltage is marked. Pay careful attention!
 Ethernet 10/100Mbps RJ45 socket
 4x 4way pluggable terminal blocks for pixel strip outputs. GND, Clock [CK], Data [DA], V+
 1x 3way pluggable terminal block for DMX512 port.
 Warning not all pixel strips use the same wire color code. Double check the signal names match wire colors.
 Insulated board carrier with optional DIN rail clips available.