User Manual

DMXking.com • JPK Systems Limited • New Zealand

0106-700-1.1

SETTINGS TAB

Make changes as required then click “Update” to save settings in your LeDMX4 PRO unit.

The following table explains each of the settings parameters.

Parameter

Usage

Update Rate

Frequency LED strip receives updates from Incoming Universe data. Universe Sync takes

precedence.

Synchronization Mode

This setting is deprecated from v3.0 firmware onwards. Universe sync now occurs

automatically if Art-Net Sync, sACN Universe Sync, or Madrix Post Sync are present on the

network.

Pixel Mapping Mode

RGB pixel mapping to DMX512 data. Raw 1U | Raw 2U | RGB remap 1U | RGB remap 2U |

Full mapping with group size, zigzag and direction. Of note full mapping of 340 pixels may

actually span 3 universes depending on the start channel and pixel count.

Incoming Universes

These 16 universes are a filtering mechanism. All universes mapped to Ports must be

included otherwise data won’t be received. Note when sACN Universe > 32767 is specified

Art-Net wraps back to universe 00:0:0 again.

Raw 1U/2U or RGB 1U/2U Pixel Mapping Modes are recommended unless your software package is not capable of re-mapping

pixel locations. Most packages are now capable of this functionality which reduces processing requirements on the LeDMX4 PRO

itself. Note RGBW mapping can be achieved using the Raw 1U/2U modes and will be fully supported in a future firmware release.