Application Guide

DMXking.com • JPK Systems Limited • New Zealand
0104-701-1.0
4
BASIC SETUP
To configure record/playback features use eDMX Configuration v1.14+ (Windows OS). Firmware v3.0+ is required.
The Recorder tab contains all settings and manual controls required for operation of the record/playback features. There are
other methods of control and triggering which are presented in other sections.
Playback Enable and Recorder Enable provide device wide control over what actions may occur through other controls or
triggers. By default, both options are disabled and typical usage would be enabling both during show recording activities then
disabling Recorder once the show(s) are stable so no accidental overwriting occurs.
The Controls panel contains a Controls Scope selection. You can direct Control commands to either the Selected Device or All
Devices on a local area network segment through broadcast commands. Operation sequence is typically select a Show from the
dropdown list then click Select Show followed by Play or Record. Stop will immediately stop either playback or recording.
SHOW RECORDING
BASIC OPERATION
Show recording can be initiated through the Controls panel or via network through Art-Net Trigger commands (refer to section
on Art-Net Control).